• Flange

The project’s Flanges could have entered the program through the following forms:

  • Body Flange
  • Nozzle

The figure below indicates an example of this report.

Fig. 124 – (Example of Material Report for Flange)

  • Stud Bolt

The project’s Stud Bolts could have entered the project through the following forms:

  • Body Flanges
  • Blind Flange For Nozzles
  • Extra Part as Stud Bolts

Stud bolts which are used for Body Flanges and Blind Flanges have standard dimensions, and are produced automatically in the software at the time of inserting the data for the respective Flange. However, dimensions of Stud Bolts that enter the software through Extra Part as Stud Bolt page depends on the project’s needs as well as the user’s diagnosis and meticulousness. These pieces might enter the program the software for heat exchangers or any other objective. Diameters of the Stud Bolts in use in standard Flanges are based on inch, and their lengths on millimeter. On Extra Part as Stud Bolts page, likewise, you can insert the diameter based on millimeter. In any case, these pieces compose our desired report, provided that they are accumulative. The figure below indicates an example of this report.

Fig. 125 – (example of Material Report for Stud Bolts)

Leave a Reply

Your email address will not be published. Required fields are marked *